基本參數/PARAMETER
| 型號 | KTD0623-0651K0101 |
| 電氣壽命 | 100000 |
| 絕緣電阻 | ≥100MΩ |
| 接觸電阻 | ≤100mΩ |
| 操作力 | 5.0±1N |
| 開關行程 | 1mm +0.2/-0.3mm |
| 最大額定值 | 50mA DC16V |
|
最小額定值 |
10uA DC1V |
|
耐電壓 |
AC 250V |
|
操作溫度 |
-40~90℃ |
| 端子形狀 |
折彎腳 |
| 端子數 | 4 |
產品規(guī)格書/SPECIFICATIONS
安裝孔尺寸圖/MOUNTING HOLE DIMENSIONS
電路圖/SCHEMATIC
焊接條件/WELDING CONDITIONS
注意事項/PRECAUTIONS
1.1開關浸焊后，注意不要用溶劑清洗。
After switches were soldered,please be careful not to clean switches with solvent.
1.2在使用烙鐵的情況下，焊錫溫度應在350℃以下、3秒以內。
In the case of using soldering iron, soldering conditions shall be 350℃max and 3 sec.max.
1.3浸焊后，注意不要在頂部施加負荷。
Right after immersion welding;please be careful not to load to on the knobs of switches.
2設計中應注意的事項( Design instructions):
2.1印刷基板的安裝孔尺寸參見產品圖。
Follow recommended P.W.B. piercing plan in outside drawing page.
3注意點(Note):
3.1注意不要施加超負荷的壓力或晃動開關
Please be cautions not to give excessive static load or shock to switches.
3.2開關浸焊后，印刷基板注意不要疊放。
Please be careful not to pile up P.W.B.after switches were soldered
3.3保管時尤其應注意避開高濕高溫和有腐蝕性氣體的環(huán)境。如需要長時間保存，請不要打開包裝箱。
Preservation under high temperature and high high humidity or corrosive gas should be avoided
Especially . When you need to preserve for a long